Here's a sweet little sign that would be a perfect addition to a favorite Mom's heart!
Materials needed for this Mother's Day project:
3, 4,5, or 6" square 3/4" wood
Mod Podge - matte
Brush
Sandpaper
3, 4,5, or 6" square 3/4" wood
Mod Podge - matte
Brush
Sandpaper
1. Step lightly sand smooth any rough spots and edges | |
Laser prints can be purchased from most copy locations such as Staples.
For best results when using Mod Podge finish as a sealer, a laser print will work much better - verses a inkjet print. With an laser print, the ink will not smear and run.
If you must print with a inkjet printer, an alternative to this project is to protect the image with a sheet of clear contact paper (before gluing to the wood).
Place a sheet of clear Contact over the print. Trim up to size. Once you have the protected print with the clear Contact on top, then you can use the sealer and adhere the print to the wood.
No need to seal the top layer because the clear contact is all you need to protect the print.
If you must print with a inkjet printer, an alternative to this project is to protect the image with a sheet of clear contact paper (before gluing to the wood).
Place a sheet of clear Contact over the print. Trim up to size. Once you have the protected print with the clear Contact on top, then you can use the sealer and adhere the print to the wood.
No need to seal the top layer because the clear contact is all you need to protect the print.